MFlenses - 数码时代的新生
MFLenses 2026

手动对焦镜头论坛

通过维修记录、实拍样片和图文丰富的档案帖,探索老镜头的世界。

通过维修记录、实拍样片和图文丰富的档案帖,探索老镜头的世界。
精选

论坛首页的合作伙伴展示位。

c-mount to micro 4/3
查看上一个主题 :: 查看下一个主题  


Reply

hi,

can any one tell me how much the lens may stick out from the back of the c-mount adapter
Used whit a Epl-1

Ty


Reply

That is lens dependent , but usually safe for micro 4/3


Reply

The length of the thread for c-mount is specified to be 3.8 mm (0.15-inch?). Since the c-mount register is 17.526 mm and the m4/3 register is 20.0mm, ANY c-mount lens, when correctly mounted, will have the start of the threaded mount 13.726 mm from the sensor. Usefully, this means you can check whether the lens will reach infinity focus by measuring the amount by which the c-mount thread protrudes from sensor side of the adaptor. From memory, there should be a mm or so protrusion for infinity focus.

I do not know if there is also a specification on how much the last optical element may protrude past the rear of the thread, but the few lenses I have seen either do not protrude at all or have very little protrusion. Since the protrusion would have to be pretty large (~10mm?) to get anyway near the shutter plane, there is evidently little or no risk of a c-mount lens protruding far enough into the camera to cause damage.


Reply

Unfortunately this is not true, as only the thread and the flange focal distance are defined, but NOT the BFL (back focal distance i.e. last lens element to sensor/film), see http://en.wikipedia.org/wiki/C_mount

There are lenses that protrude quite deeply into a camera. Take that Fujinon as an example, where the BFL is only 3.03mm!!



Well, it wouldn't fit anyway, but just to illustrate my point. But I also have cmount lenses here, that would damage the sensor if completely screwed in!!