MFlenses - 数码时代的新生
MFLenses 2026

手动对焦镜头论坛

通过维修记录、实拍样片和图文丰富的档案帖,探索老镜头的世界。

通过维修记录、实拍样片和图文丰富的档案帖,探索老镜头的世界。
精选

论坛首页的合作伙伴展示位。

Stuck aperture
查看上一个主题 :: 查看下一个主题  


Reply

I'm currently trying to fix the stuck aperture of an Hanimex 135mm, lighter gaz seems to be of limited effect, does someone try to use WD40 for that, or any other liquid?
I fear to completely unassemble the blades!
Thanks

Jean Claude


Reply

jclaude 写道:
I'm currently trying to fix the stuck aperture of an Hanimex 135mm, lighter gaz seems to be of limited effect, does someone try to use WD40 for that, or any other liquid?
I fear to completely unassemble the blades!
Thanks

Jean Claude


Well I wouldn't go beyond lighter fuel for a quick fix, if that doesn't work then it's not always necessary to take the blades apart but just clean the the whole assembly in:- well some say hot soapy water others say lighter fuel.


最后由 Excalibur 于 周三 11月 16, 2011 8:55 am 编辑;共编辑 1 次


Reply

Hello J-C

Never, EVER, use WD40!! It might have a good effect to begin with, but after a short time the blades will become totally stuck. This have been learned through bitter experience! Smile

The blades need to be completely clean and dry. Keep applying the lighter fuel and working the blades at the same time and use a cool hairdryer to dry them. It requires a lot of time and patience!

If you can see how to remove the complete aperture assembly without dismantling it, to work on the other side, that might have some success.

Sometmes the springs which activate the blades and the mechanism can become stretched and weak. Also the mechanism might need cleaning/lubrication. Either of these can affect the speed of the blade movement too.

Remember - patience is the word! Smile


Reply

I use sometimes WD 40 - but only if screws are corroded that I can not open them. For the application I use cotton swapy - don´t even think about using the spray.
And after I open the screws I have to clean very much to get all WD 40 away.

To use WD 40 without planning to open all seems very difficult, it spreads around!

For stuck or slow iris blades I use isopropanol alcohol. Iris need no grease or oil!


Reply

Thanks all for your replies, I will avoid WD40 and continue with lighter fuel, some more time!

Jean Claude