MFlenses - 数码时代的新生
MFLenses 2026

手动对焦镜头论坛

通过维修记录、实拍样片和图文丰富的档案帖,探索老镜头的世界。

通过维修记录、实拍样片和图文丰富的档案帖,探索老镜头的世界。
精选

论坛首页的合作伙伴展示位。

Need to do some testing . . .
查看上一个主题 :: 查看下一个主题  


Reply

As many probably know I am mainly a Minolta user for 35mm slr and as of late have a couple MF cameras I'm learning to use. My quaundry is a side issue, as I am trying to have a small M42 kit . . .

I have just put a roll through my Yashica TL Electro X and I have a large area of blank exposures. The first 2 exposures are daytime shots and turned out, the last ones that turned out I used an external meter with. Confused For those not in the know - the meter on this camera is an arrow acting as a memory aid as to which way to turn the appeture and exposure controls.

In the past I had some issues with a Praktica PLC II I got off of Attila - these problems are not the camera's fault, but are probably the user's lack of familiarity with that camera! Embarassed

With the Hassy came an Asahi Pentax SP1000. (By the way a question to any of our Pentax experts - why are SP1000s I see on the net marked Honeywell and mine is Asahi? Is this simply because mine didn't come through the states?) The camera looks to be in good condition and is M42.

So I think I would like to run film through all three head to head -
using TTL meter vs hand held (same shot, same light etc). If I do this here's a question . . .
I don't want to run a 24 exp. through each as they might sit for a while (so far locally I can't find 12 exp).
I remembered something I heard once upon a time about switching between ASA's/ colour + B&W. After you have shot for a while and you want to switch do the following . . .
1-note exposure you're at
2- rewind film until it is just off of the take up real (you may have to listen for it)
3-switch in next roll
4 - to switch back reload film and with lens cap on it & in dark shoot and wind the camera until you're at the exposure you left off at.
I thought I might try this with the cameras - 1/3 for each with the 1st shot a piece of paper noting the camera.
Has anybody done these old school switch outs of film mid roll?

Secondly - does anyone use a camera that has a metering problem, using an external meter with that camera because you like the camera too much?

Jim


Reply

I think the The TL-Electro-X uses an "Electronic Shutter Speed Dial", basically a variable resistor. If it is dirty, the speed that you set is not the speed that you get. Dry-fire it, looking through the back and see if the speeds look good. Set it at in-between speeds, and see if it "goes wacky". Mine settled down after working with it.


Reply

The TL-Electro-X so far for me has been relatively accurate and reliable. Only thing I'm suspecting right now is the combination of a battery getting weak and being out in sub-freezing weather seems to 1) make the meter indicate wildly shorter exposures/smaller apertures than called for, and 2) the shutter may go towards 1/1000. (With the Yashica electrics, when the battery goes the shutter goes to the maximum speed.)

But indoors, it seems ok. So I haven't actually replaced the battery. On your test roll, do you have a recollection of exposure settings for the frames that didn't come out?

Re. SP1000 - these are truly excellent, my favorite (so far) Spotmatic. Asahi vs. Honeywell, they seemed to co-exist depending on who was importing them where. (Mine was stolen by my daughter.)

Rather than swap films mid-stream, why not keep two cameras each loaded with different film?


Reply

Nesster 写道:
. . .
Rather than swap films mid-stream, why not keep two cameras each loaded with different film?


I know my habits and I wanted to guarantee a decent "turn around" for this test - I've been known to forget about a camera I don't use regularally sitting with film in it. Embarassed

I was more hoping for an accurate head to head test between them - hopefully to find an M42 of choice.

Jim


Reply

I used to do mid-roll swaps regularly, just as you describe. It's easy.


Reply

I'll be doing the mid spool swap as we were taught in our photography classes in 1983 (there were a couple people who had to share a camera and due to due dates etc. . .

If the results are interesting I'll pass them along.

Jim


Reply

Rob Leslie 写道:

As for swapping a film part through I have often heard of it but I have never done it, or know of anybody who has/does. 24 or 36 exposures aren’t a lot and are never enough.
I should allow at least four frames leeway if you do it, maybe two if you are sure of your loading routine, or risk lost shots,

One lost frame as spacing is enough. What I would do is write "set 13" on the leader if the camera had shot 11 before removal.

edit
Sorry Rob, the forum burped as I replied and your post has vanished.


Reply

j.lukow 写道:

With the Hassy came an Asahi Pentax SP1000. (By the way a question to any of our Pentax experts - why are SP1000s I see on the net marked Honeywell and mine is Asahi? Is this simply because mine didn't come through the states?) The camera looks to be in good condition and is M42.

Yes, Honeywell was the importer of US Spotties.